home *** CD-ROM | disk | FTP | other *** search
/ Ham Radio 2000 / Ham Radio 2000.iso / ham2000 / mods / kenwood / sb949.doc < prev    next >
Text File  |  1989-07-13  |  2KB  |  53 lines

  1.  
  2.  
  3. SB-949
  4. TS-440S PROTECTING Q33                           01/20/89
  5.  
  6.  
  7. If pin 7 (RL) of the remote connector is accidently
  8. connected to ground, current from the 14 volt line (14L)
  9. will damage transistor Q33 on the IF unit. This will prevent
  10. the radio from transmitting. To protect Q33, a 4.7 ohm
  11. resistor should be installed in series with the RL line on
  12. the foil side of the IF board. In the event that pin 7 is
  13. connected to ground, the resistor will open, but the
  14. transceiver will still be capable of transmitting.
  15.  
  16.  
  17. REQUIRED PART:
  18.  
  19. 4.7 OHM, 1/6 WATT RESISTOR ........ RD14CB2C4R7J
  20.  
  21.  
  22. 1.    Disconnect the power supply and antenna from the
  23.     transceiver.
  24.  
  25. 2.    Using a #2 Phillips screw driver, remove the 9 screws
  26.     from the top cover of the transceiver. Remove the cover
  27.     and unplug the speaker wire.
  28.  
  29. 3.    Locate connector 19 on the IF unit.
  30.  
  31. 4.    Using a #1 Phillips screw driver, remove the 7 screws
  32.     that secure the IF unit to the chassis of the
  33.     transceiver.
  34.  
  35. 5.    Pull the board up and rotate it towards the front of the
  36.     transceiver to expose the foil side of the board.
  37.  
  38. 6.    On the foil side of the board, locate the trace that is
  39.     connected to pin 3 (brown wire) of connector 19.
  40.  
  41. 7.    Using a craft knife, cut the trace comming from pin
  42.     three so as to open the foil trace.
  43.  
  44. 8.    Solder the 4.7 ohm resistor across the now open trace
  45.     (i.e. in series with the trace).
  46.  
  47. 9.    Assemble the transceiver by reversing steps 1 - 5.
  48.  
  49. This is an optional change that may not be covered under
  50. warranty.
  51. Time required for this modification is 0.5 hrs or less.
  52. (C) 112188TKC
  53.